How To Use Eleaf iCard Kit

Assembling:

1. Remove the cover, and pull up the mouthpiece;

2. Drip a few drops of e-liquid directly into the atomizer head to make the coil

inside fully saturated before first use;

3. Insert the atomizer head into the tank, screw it down, and tighten it by the use of the little metal piece inside the mouthpiece and then put the mouthpiece back;

4. Put the device upside down, slide the switch to unlock the tank section; 

5. Rotate clockwise the tank section to reveal the fill port, and slowly inject e-liquid into the tank;

6. Turn the tank section back and slide the switch to lock it, and finally the device is ready for use.

Power on/off: press the button 5 times in quick succession within two seconds,
and the indicator light will flash 5 times to show the device is powered on. In the same way, it can also be powered off.

Vaping: keep holding the button to take a puff when the device is powered on.
When vaping, the indicator light stays lit.

Charging: the device can be charged by connecting it with 1A wall adapter or
computer via the USB cable. The indicator light is red during charging and goes
out when fully charged.

Properties and Protections:

Resistance Range: 0.4Ω-3.0Ω

Atomizer Protection: every time when vaping time exceeds 15 seconds, the
indicator light flashes 10 times and the output cuts off automatically.

Short Circuit Protection: if short circuit occurs before vaping, the indicator light will flash 5 times and the output cuts off automatically when you start to vape; if short circuit occurs during vaping, the indicator light will flash 3 times.

Low Voltage Protection: when the voltage of the device is lower than 3.3V, the
indicator light flashes 20 times and there is no output when vaping. Charge the
device to reactivate it.

Output Voltage: when the voltage of the device is no lower than 3.7V, the output
voltage is constant 3.7V; when the voltage of the device is lower than 3.7V, the
output voltage changes according to the battery level.