Vaporesso Luxe Nano User Manual - Instruction/Problems

Luxe Nano Kit SPECIFICATIONS 

Tank Capacity: 3.5ml/2ml Display: 1.3” TFT Color Screen Built-in Battery: 2500mAh Power Range: 5-80W Resistance Range: 0.03~5Ω

HOW TO USE Vaporesso Luxe Nano

STEP1 : FILLING THE E- JUICE Uncrew the drip tip directly, then you can fill your favorite E-juice through the opening.

STEP2: INSTALL THE TANK

1) When in SS/NI/TI (VT)mode, atomizer's type need to be reganized when a new one is installed.

2) Suggested mode for different coil: VW-N mode for tank with QF MESHED and QF STRIPS coil , SS(VT) mode for SK CCELL coil.

STEP3: POWER ON THE DEVICE 1)Turn device on by pressing the power button 5 times in 2 seconds, repeat to power off. 2)For your safety, If you vape continuously for more than 10 seconds, it will display "10s time over"and device will stop working temporarily. 3)3 press of MODE button is request when you enter MENU after  unit waken up from sleep.

UI interface

STEP4: CHOOSE YOUR FAVERITE MODE

1)VW-H /VW-N /VW-S (Variable Wattage mode - high/normal/ soft): it will automatically select the adequate average wattage for your atomizer If you switch between different ohms resistance.

2)SP (Super Player mode): In this mode, it will support broader resistance range from 0.03Ω to 5Ω, which is adaptive to mainstream RDA tanks.

3)VT-SS/VT-NI/VT-TI : Variable temperature control mode for Stainless Steel/Nickel/Titanium material.

4)VV(Variable Voltage mode): You can manualy adjust the voltage to match the resistances of the coil you use, the higher resistance of the coil you use, the higher voltage it require correspondingly.

5)CCW (Custom Curve of Wattage mode): To use the up and down buttons to customize you own curve of wattage output line ,move to the next bar with a quick press of the fire button,press the mode button to save and exit when setting is done.

6)BP (Bypass mode): Direct output voltage mode depends on battery level, the higher the battery level the higher the output voltage, supported coil resistance range: 0.05-5ohm.

7)CCV (Custom Curve of Voltage mode in DIY MENU): you can use the up and down buttons to customize the curve of voltage output line,move to the next bar with a quick press of the fire button , press the mode button to save and exit when setting is done.

8)TCR-M1/M2 (Temperature Coefficient of Resistance mode ,in DIY MENU) Note: when in VT and TCR mode, the Celsius and Fahrenheit can be switched by adjust to its max value in the main page.

9)SMART ON/OFF(in SET MENU):It is a advanced Variable Wattage mode, when this function is enable, it can change intensity according to the coils resistance levels within a safe limit in VW-H/N/S mode.

10) AUTO ON/OFF(in SET MENU): The Auto function taking away any operation difficulties switching between VW-H and VW-N or between VT-H and VT-N.